Z207940-0A Page 1 of 1 ©2020 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com 1120 Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries. Other companies’ trademarks are hereby acknowledged to belong to their respective owners. NOTICE • This product is not intended for life or safety applications. • Do not install this product in hazardous or classied locations. • Read and understand the instructions before installing this product. • Turn o all power supplying equipment before working on it. • The installer is responsible for conformance to all applicable codes. If this product is used in a manner not specied by the manufacturer, the protection provided by the product may be impaired. No responsibility is assumed by the manufacturer for any consequences arising out of the use of this material. Installation Guide Humidity Product Identification Product Overview HS Series Generation 2 Replacement Humidity Sensors work with the HW2 and CW2 Series (with humidity option) only. The HW2 and CW2 Series sensors use an onboard RH sensor. When a replacement sensor is installed into the socket on the HW2 or CW2, the reading from the replacement sensor is used. The replacement sensor can subsequently be replaced as needed. HS Series Gen. 2 Replacement Humidity Sensors Installation 1. Disconnect power to the unit. 2. Remove faceplate. 3. Install the plastic standoff into the hole in the circuit board above the replaceable RH sensor socket. 4. Align new Replacement Humidity Sensor into the socket and standoff. Press on socket until it clicks into place. Then press down on the top of the sensor until the standoff snaps into place. 5. Reconnect power and replace faceplate. HS Generation 2 HS AccuracyNIST 1 = 1% 2 = 2% N = NIST X = None (2% models only) HS Example: 2X This side up for placement onto board. Standoff hole Socket connector Note: HS Generation 2 sensors are covered by a 1-year limited warranty. Note: The Veris HD, HN, HP, HO and legacy HWL/HWX and CWL models require HS Series Generation 1 replacement sensors.Next >