F4-CGM General Purpose Application Controller Catalog Page General Purpose Application Controllers (F4-CGM) The CGM09090 General Purpose Application MS/ TP Controller (CGM) is an equipment controller that runs pre-engineered and user-programmed applications, and provides the inputs and outputs required to monitor and control a wide variety of HVAC and other facility equipment. CGM09090 equipment controllers operate on an RS-485 BACnet MS/TP bus as BACnet Advanced Application Controllers (B-AACs) and integrate into Johnson Controls and third-party BACnet systems. CGM equipment controllers include an integral real- time clock, which enables the controllers to monitor and control schedules, calendars, and trends, and operate for extended periods of time as standalone controllers when offline from the Facility Explorer ® system network. For product application details, refer to the Facility Explorer CGx, CVx Equipment Controllers Product Bulletin (LIT-12013225). Figure 1: FX-CGM09090 General Purpose Application Controller Features and benefits Sleek and modern packaging and styling Provides a modern, aesthetically pleasing industrial design. Standard hardware and software platform Uses a common hardware design throughout the family line to support standardized wiring practices and installation workflows. Also uses a common software design to support use of a single tool for control applications, commissioning, and troubleshooting to minimize technical training. High memory capacity and fast processing power Provides application engineers with the horsepower to meet sophisticated control requirements. Auto-Tuned Control Loops Reduce commissioning time, eliminate change-of-season re-commissioning, and reduce wear and tear on mechanical devices. Patented Proportional Adaptive Control (P- Adaptive) and PRAC Provides continuous loop tuning. Standard BACnet protocol Provides interoperability with other Building Automation System (BAS) products that use the widely accepted BACnet standard. Models to support both BACnet MS/TP and N2, with auto-detection of the communications protocols Controller auto-detects the BACnet MS/ TP or N2 protocol that is connected to it, which enables the same controller to support multiple communication protocols without the need to purchase a special model per protocol, and without extra manual setup. LIT-1901108 2019-10-29Next >