Installation Guide Accessories Z202288-0E Page 1 of 1 ©2015 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com 0115 Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries. Other companies’ trademarks are hereby acknowledged to belong to their respective owners. TM HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH • Follow safe electrical work practices. See NFPA 70E in the USA, or applicable local codes. • This equipment must only be installed and serviced by qualified electrical personnel. • Read, understand and follow the instructions before installing this product. • Turn off all power supplying equipment before working on or inside the equipment. • Use a properly rated voltage sensing device to confirm power is off. DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE INDICATION • Only install this product on insulated conductors. Failure to follow these instructions will result in death or serious injury. A qualified person is one who has skills and knowledge related to the construction and operation of this electrical equipment and the installation, and has received safety training to recognize and avoid the hazards involved. NEC Article 100 No responsibility is assumed by Veris Industries for any consequences arising out of the use of this material. DANGER NOTICE • This product is not intended for life or safety applications. • Do not install this product in hazardous or classified locations. • The installer is responsible for conformance to all applicable codes. • Mount this product inside a suitable fire and electrical enclosure. AH 02/03/04 1/2 Amp Fuse Packs for Applications to 600VAC Specifications Fuse1/2 Amp 600VAC slow blow, 200kAIC, equivalent to Bussmann FNQ-R-1/2 Wire14AWG, 18”, 600VAC Warranty5 years Installation Disconnect power before installation. 1. Connect fuse to circuit as shown below. Fuse housing is labelled, showing which end must be connected to the load. 2. Fuses are replaceable. Use a 1/2 Amp 600 VAC slow blow Bussman or equivalent. To replace, unscrew the fuse housing in the center, remove used fuse, and insert new fuse, with the flat end of the fuse entering the Load side of the fuse housing. Screw the housing back together, and restore power. Note: the fuse packs are supplied with hi-interrupt capability AC fuses installed in the fuse housings. These fuses are not rated for DC use. AH04 (three-fuse kit) pictured here. AH02 contains only one fuse; AH03 contains two fuses. RoHS Compliant 18 “18 “ To Power SourceTo Meter (Load) FuseNext >