The performance specifications are nominal and conform to acceptable industry standards. For applications at conditions beyond these specifications, consult the local Johnson Controls office. Johnson Controls, Inc. shall not be liable for damages resulting from misapplication or misuse of its products. © 2008 Johnson Controls, Inc. www.johnsoncontrols.com 1 of 1 Facility Explorer FX Tools Pro Software Package Description FX Tools Pro is a Microsoft® Windows® based software package that comprises FX Builder, FX CommPro, and other tools/utilities used to program, configure, test, download, and commission Heating, Ventilating, Air Conditioning, and Refrigeration (HVACR) applications for all Facility Explorer Field Controllers. FX Builder provides a fully programmable environment for developing HVACR control applications. Its graphical, function-block programming method provides you with a powerful and flexible yet easy-to-use tool to develop control applications. Selection Chart Technical Specifications Product Code NumberProduct Description LP-FXTPRO-0FX Tools Pro CD-ROM - New User LP-FXTPRO-6FX Tools Pro CD-ROM - Upgrade only LP-KIT200-000CN2 Commissioning Adapter: Includes port powered RS-232 to RS-485 converter and wiring harness with mating connectors for FX Field Controller supervisory link interface LP-KIT204-000CBACnet Commissioning Adapter: Includes BACnet Internet Protocol (IP) to Master-Slave/Token-Passing (MS/TP) adapter, Ethernet cable, and Universal Serial Bus (USB) cable (USB port required to power the adapter) LN-75010USB to L ON W ORKS TP/FT-10 Network Interface needed for FX CommPro LON FX Tools Pro System Requirements Operating SystemMicrosoft Windows 2000 (with Service Pack 4 or later) Microsoft Windows XP® (with Service Pack 1 or later) Hardware Requirements ProcessorIntel® Pentium® Processor, 500 MHz or higher RAMMinimum 512 MB RAM (1 GB recommended) Hard Disk•60 MB for storage of FX Tools Pro •2.5 MB (typical) to 6 MB (maximum) for storage of each application file DisplayDisplay resolution 800 x 600 16-bit (32,768) color minimum Communication•Ethernet network interface card 10/100 mega bits per second (Mbps) needed for FX CommPro BACnet •DB9 male serial port needed for FX CommPro N2 •USB port needed for FX CommPro LON and for powering BACnet Commissioning Adapter Software RequirementsMicrosoft Internet Explorer® Version 5.0 or later Microsoft .NET Framework Version 2.0 FX Tools Pro Code No. LIT-1900373 Issued October 28, 2008 The Application Wizard is a feature of the FX Builder tool which provides an easier alternative to fully programming control applications. The Application Wizard guides you through creating applications via factory designed and tested application templates and easy-to-use configuration screens. FX CommPro is an online tool used to download and commission Facility Explorer Field Controllers. It is available in three versions (N2, L ON W ORKS ®, and BACnet®) to interface with all the networking protocols supported by the field controllers. Refer to the FX Tools Pro Software Package (LIT-12011086) for important product application information. Features •FX device support •graphical environment •application wizard •reusable macro assemblies •offline simulation •online commissioningNext >