Doc # INT-100051-001 Part No. 191505 Rev. 5 DITEK Technical Support Available 24/7 1-888-472-6100 www.ditekcorp.com DITEKCorporation ONE DITEK CENTER 1720 Starkey Road Largo, FL 33771 I N S T A L L A T I O N INSTALL INSTRUCTIONS DTK-LVLP SERIES LOW VOLTAGE LINE PROTECTION NOTE: This device is intended for indoor use on isolated loop circuits, data, or low voltage telecommunication circuits. 1. Before beginning installation, discontinue power to the circuit. 2. This device must be connected in series between the field wiring and the equipment to be protected. 3. Securely mount the base close to the circuit being protected using the double sided tape (supplied), or two #8 screws (not supplied). 4. Allow the surge protector reaction time by providing 3-5 wire feet of distance between the dtk- unit and the equipment to be protected. 5. Allow for the wire distance from the surge protector to protected equipment to be greater than the wire distance from the surge protector to ground. 6. Use one common ground per system to eliminate the possibility of a difference in ground potentials. 7. Connect side #1 "in" with the incoming field wires, and connect the opposite side of the terminal block to the equipment to be protected. 8. After all connections have been made and no hazards exist, restore power. 9. If you have any questions call technical support at: 1-888-472-6100. 4LVLP3LVLP2LVLP1LVLP MODEL DTK- VRMS SUFFIX 13095755030146 RUVSGRSPKOPXLVXD LOW VOLTAGE SURGE PROTECTION (SEE INSTRUCTIONS) Side #1 "IN" Side #1 "IN" (SEE INSTRUCTIONS) DXLVOPXSPKSGRRUV 61430507595130 SUFFIX VRMS MODEL DTK- 1LVLP2LVLP3LVLP4LVLP -SCP -SCP -SCP -SCP LOW VOLTAGE SURGE PROTECTION MODEL DTK-1LVLP DTK-2LVLP DTK-3LVLP DTK-4LVLP # WIRES PROTECTED 2 WIRES 4 WIRES 6 WIRES 8 WIRES 130 VOLTS RMS 95 75 5030 14 6 R U V S G R S P K O P X L V X D SURGE PROTECTION SLOT 0.180" x 0.240" TYP. 2 PLACES 3.00" 1.60" 1.165" 1.555" 0.10" 2.60" 0.20"Next >